瑞氏染液的原理及使用方法-技术文章

上海金畔生物科技有限公司瑞氏染液的原理及使用方法

瑞氏染液由酸性染料伊红和碱性染料美蓝组成的复合染料,溶于甲醇,后解离为带正电的美蓝和带负电的伊红离子。伊红通常为钠盐,有色部分为阴离子。美蓝通常为氯盐,有色部分为阳离子。甲醇的作用:一是溶解美蓝和伊红,使其解离为有色美蓝正离子的和伊红负离子。后两者可以选择性地吸附于血细胞内的不同成分而使其着色;二是固定细胞形态,加速染色反应,增强染色效果。

瑞氏染液染色原理:

瑞氏染色法使细胞着色既有化学亲和反应,又有物理吸附作用。瑞氏染料由酸性染料伊红和碱性染料美蓝的氧化物(天青)组成,其深于甲醇后,解离为带正电的美蓝和带负电的伊红离子。各种细胞由于所含化学成分不同,对染料的亲和力也不一样,因此,染色后各种细胞呈现出各自的染色特点。

瑞氏染液配置方法:

瑞士染料830gm或1g;

甲醇(AR) 500ml或600ml;

先称干燥(事先放入温箱干燥过夜)瑞氏染料放置乳钵内,用乳棒轻轻敲碎染料成粉末,再行研磨至听不到研芝麻声即呈细粉末,加少许甘油或甲醇溶解研磨,使染料在乳缸内显“一面镜”光泽,而无染料粉粒沉着。再加较多量甲醇研磨呈一面镜光亮,静置片刻,将上层液体倒入一清洁储存瓶内(最好用甲醇空瓶),再加甲醇研磨,重复数次,至乳钵内染料及甲醇用完为止,摇匀,密封瓶口。存室温暗处,储存愈久,则染料溶解、分解就越好,一般储存3个月以上为佳。

瑞氏染液使用说明:

1、取涂片、自然干燥。

2、滴加瑞氏染液染3分钟,使标本被其中甲醇所固定。

3、加等量PH6.4的磷酸盐缓冲液(或等量超纯水)轻轻晃动玻片, 与瑞氏染色液混匀,静置5分钟。

4、水洗、吸干、镜检。

5、细菌染成蓝色,组织细胞胞浆红色,细胞核蓝色。

注意事项:

1、PH对细胞染色有影响。由于细胞中各种蛋白均为两性电解质,所带电荷随溶液PH而定。对某一蛋白质而言,如环境PH<PI(蛋白质的等电点),则该蛋白质带正电荷,即在酸性环境中正电荷增多,易与酸性伊红结合,染色偏红;相反,则易与美蓝天青结合,染色偏蓝。为此,应使用清洁中性的玻璃片,稀释液必须用PH6.4~6.8的确良缓冲液。冲洗玻片必须用流水。

2、未干透的血膜不能染色,否则染色时血膜易脱落。

3、染色时间与染液浓度、染色温度成反比;而与细胞数量成正比。

4、冲洗时不能先倒掉染液,应用流水冲去,以防染料沉淀在血膜上。

5、如血膜上有染料颗粒沉积,可加少许甲醇溶解,但需立即用水冲洗掉甲醇,以免脱色。

6、染色过淡,可以复染。复染时应先加缓冲液,创造良好的染色环境,而后加染液,或加染液与缓冲液的混合液,不可先加染液。

7、染色过深可用水冲洗或浸泡水中一定时间,也可用甲醇脱色。

8、染色偏酸或偏碱时,均应更换缓冲液再重染。

瑞氏染液为上海金畔生物科技有限公司常备货产品,货号为G1040。瑞氏染料是由碱性染料美蓝(Methvlem blue)和酸性染料伊红(Eostm Y)组成的复合染料,溶于甲醇 。在正常情况下,血膜外观染成淡紫红色。显微镜下,红细胞呈粉红色,在厚薄均匀处,略有碟状感。白细胞浆中颗粒清楚,并显示出各种细胞特有的色彩。细胞核染紫红色,核染色质结构清楚。

nunc

L-Glutamate Oxidase(Recombinant)25 L-谷氨酸氧化酶(重组) 品牌:Yamasa


品牌:Yamasa
CAS No.:
储存条件:-20°C
纯度:
产品编号

(生产商编号)

等级 规格 运输包装 零售价(RMB) 库存情况 参考值

632-30471

25 U 6,360.00


* 干冰运输、大包装及大批量的产品需酌情添加运输费用


* 零售价、促销产品折扣、运输费用、库存情况、产品及包装规格可能因各种原因有所变动,恕不另行通知,确切详情请联系上海金畔生物科技有限公司。

产品描述相关资料下载相关产品浏览记录 请联系客服

Encapsula Mannosylated Fluorescent-DiA Macrophage Depletion Kit 货号:CLD-8938-15ML 品牌:Encapsula NanoSciences


Encapsula Mannosylated Fluorescent-DiA Macrophage Depletion Kit

货号:CLD-8938-15ML

规格:15ml

品牌: Encapsula NanoSciences

报价:20425.00

商品描述

Mannose receptor targeting by mannosylated liposomes has been demonstrated for a variety of mannosylated lipid conjugates in a variety of liposome morphologies and compositions in several different in vitro and in vivo models. A very large number of publications is about using a hydrophobic derivative of mannose (4-aminophenyl alpha-D-mannopyranoside) rather than using a mannosylated lipid in clodronate liposomes. This is mainly due to the high cost and complexity of synthesizing and conjugating mannose to lipid. 4-aminophenyl alpha-D-mannopyranoside is commercially available and far less expensive than synthesizing mannose conjugated lipid. Why mannose Mannose is one of the carbohydrate components of many bacterial and viral cell surfaces; therefore, the ever-efficient, highly redundant immune system has evolved multiple mechanisms for identifying pathogens based on mannose recognition. The animal and plant kingdoms likewise utilize carbohydrate recognition signaling mechanisms including mannose residues. Many publications evaluate other carbohydrates as targeting mechanisms for various cell types, however mannose targeting to phagocytes appears to be one of the more specific mechanisms identified to date. Mammalian cell surface identification molecules based on mannose binding, such as the ICAM family of leukocyte adhesion molecules, target the SIGN family of mannose receptors to accomplish self-recognition in vivo. A well-known and cited study by Umezawa & Eto [1] demonstrates that liposomes containing aminophenyl mannoside were most efficiently incorporated into the mouse brain across the blood brain barrier. The radiolabeled liposomes bearing aminophenyl-alpha-D-mannopyranoside were maximally incorporated into the mouse brain after 48 hours, whereas in the spleen and liver, these radioactivities were maximum after 12 hours. The studies also showed that liposomes were most incorporated was glial cells rather than neuronal cell. The subcellular fractionation study indicates that mannose labeled liposomes are incorporated into lysosomes rich fraction both in liver and brain. There are five mannosylated fluorescent control liposome products (m-Fluoroliposome) for m-Clodrosome (mannosylated clodronate liposomes). All five mannosylated fluorescent liposomes incorporate a lipophilic dye inside their membranes. They are insoluble in water; however, their fluorescence is easily detected when incorporated into membranes. DiI, DiO, DiD, DiR and DiA cover a wide range of excitation and emission wavelengths from 300s to 900s. DiI and DiO have fluorescence excitation and emission maxima separated by about 65 nm, facilitating two-color labeling. The emission spectrum of DiA is very broad, allowing it to be detected as green, orange, or even red fluorescence depending on the optical filter used. DiI, DiO, DiD and DiR belong to the dialkylcarbocyanines family of compounds. The spectral properties of the dialkylcarbocyanines are largely independent of the lengths of the alkyl chains but are instead determined by the heteroatoms in the terminal ring systems and the length of the connecting bridge. They have extremely high extinction coefficients, moderate fluorescence quantum yields, and short excited state lifetimes in lipid environments (~4 ns). The fluorescence spectrum of the dye is shown below. You can choose the m-Fluoroliposome based on the type of the fluorescent equipment and filters that you use in your lab. Mannosylated clodronate liposomes cannot be made fluorescent simply due to the potential for inaccurate and/or uninterpretable data being generated by labelled m-Clodrosome. For more information, please refer to the technical note section.